TMPGne

[T 3 X]

Hi

I have a movie which is an AVI and I want to convert it to a MEPG (SVCD).

Anyway the movie is in 2 halfs and when I start to encode it goes fine.

After a few minutes or around 2 - 3% of the movie been encoded the movie just fails. Like it starts out saying I only have to wait 4 - 5 hours but after 2 - 3% the time blows out for 21 hours. This isnt normal behaviour when I use this program. It usually takes about 4 - 5 hours tops. The AVI files are only around 150 meg each.

Ive even downloaded the new TMPGne 2.50 and it does the same.

Any help would be appreciated.

T 3 X


<font size=-1>[ This Message was edited by: T 3 X on 2002-01-07 09:12:08 ]</font>

[detmonster]

try using virtual dub first and reencode it to avi then use tmpeg

settings:
audio->compression->divx wma audio v2[64kbps,44mhz,stereo(for audio/video)

Video->compression->divxmpeg4(low-motion)->configuration->data rate 6000

then go to file->save avi and name it

[T 3 X]

detmonster

No good. Virtual Dub wont let me access the Avi file stating something along the lines that Micro$soft has asked virtual dub to remove the ability to convert asf blah blah blah.

So I went and got my hands on a Virtual Dub 1.3 and that wont do it either.

Any ideas??

T 3 X