mpg to vcd problem

[msson]

i'm attempting to burn my final CD. i have all of the .vob's and can put them into the .mpg. but i have not been able to successfully burn it. I'm using VCDImagerGUI and CD-RWIN but cannot get past VCDImagerGUI when trying to put my .mpg into vcd. my .mpg file size is 2.46 GB. should I be spliting my file so each cd has the 74 minutes on it. or am i able to have the whole movie on the once cd? any help would be very appriciated. thank you

[NuebieN]

Open TMPGEnc, Click on File, Choose MPEG Tools, Click on the tab Simple Demultiplex. If it's not there, get a newer version. Load up your mpeg and run it. Get bbmpg. Then..
1 Start bbMPEG (avi2mpg2)
2 Click on the [SETTINGS] button.
3 Enable MULTIPLEX VIDEO and MULTIPLEX AUDIO if they are not already
click the [Input and Output files] tab (forget about the max. size, we will do this later)
4 Click on the OPEN PS button to name the output file
5 Choose and output filename and click [SAVE]
6 Click on the OPEN VS button
7 Select the MPEG-2 video stream
8 Click on the [OPEN AS] button.
9 Select the MPEG-1 audio stream [OPEN].
10 Click on the [PROGRAM STREAM] button.
11 Set the [PROGRAM STREAM] to SVCD and then return to the GENERAL SETTINGS tab.
12 Set the MAX size as follows: 74min CD-R : 720, 80min CD-R : 780

After a few minutes, you will have smaller mpg that vcdimager will like.


<font size=-1>[ This Message was edited by: NuebieN on 2001-09-09 19:57:18 ]</font>