VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 16th Jan 2003 14:00 #1
    Bagmaster
    Bagmaster is offline
    Member
    Join Date
    Dec 2002
    Location
    Deep South of Dixie
    Search Comp PM
    Another newbie needing help. I've been using VCDEasy ver. 1.1.3 to burn my vcd's and importing my chapter info from Chapter Tractor. Now lately VCDeasy won't burn the chapters after a successful import. When I test it using PowerDVD XP it just jumps to the end of the disk. Any settings I should recheck? I mainly use default settings for VCDEasy.
    If it works, don't mess with it, don't tinker with it and don't break it.
    Quote Quote  
  2. 16th Jan 2003 15:54 #2
    puertorican138
    puertorican138 is offline
    Member
    Join Date
    Mar 2002
    Location
    United States of America
    Search Comp PM
    Make sure you have PBC enabled when creating chapters because if you don't, when you press >>| the movie will skip to the end instead of to the chapter.
    Quote Quote  
  3. 16th Jan 2003 16:09 #3
    Bagmaster
    Bagmaster is offline
    Member
    Join Date
    Dec 2002
    Location
    Deep South of Dixie
    Search Comp PM
    Thanks, I'll recheck that. I went and did a reinstall to a different location instead of the default it tries to do. It wants to install by default to my C drive, but that's my 98se drive on a dual boot setup.
    If it works, don't mess with it, don't tinker with it and don't break it.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!