Tempgenc time problem

[blank00]

I just installed TempGenc 2.58, but when i try to convert filesit takes way too long. For a 71mb file it takes 22 hrs. I went to the common problems section of this site but the tips didnt reduce the time. Please help me

[KingJohn]

What is the file type your converting ? has it been checked for bad frames ? Try using the source range (End at a few frames from the end)

Also check this

TMPGEnc
Options > Environmental setting > VFAPI plug-in > DirectShow multimedia file reader > right click, select higher priority (Do several times to get it at top) or just below any Mpeg 2 filter

[blank00]

its a mov file. The priority to Directshow is at the top of the list.

[blank00]

I also noticed that TmpGenc does not use much of my cpu. I have coolmon and it indicates that only 15% of the cpu is in use by Tmpgenc. The use of the cpu also fluctuates, which means that sometimes it will use 15% then 0% then back to 15%.

[KingJohn]

its a mov file. The priority to Directshow is at the top of the list.

.mov as in Quicktime ?... is that filter at the top ? they are always slow