VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 18th Dec 2002 01:31 #1
    dextro
    dextro is offline
    Member
    Join Date
    Dec 2002
    Search Comp PM
    k, i followed the instructions on this site

    i have my avi and my wave extracted with virtual dub

    CBR encoding works but I wanna fit on 2 Cds (1hr 30mins)
    so i ran the wizard and chose Super Video-CD NTSC VBR 1950 45min/650MB

    i tweaked all the necessary settings to have correct AR and source range

    then when I click start to encode, the source position stay on 0 the whole time, but the progress bar goes and remaining time goes down.
    the mpg is 0bytes.

    whats going on? am i just being impatient?
    Quote Quote  
  2. 18th Dec 2002 04:22 #2
    El Torro
    El Torro is offline
    Member
    Join Date
    Jul 2002
    Location
    Brussels
    Search Comp PM
    check the source range... maybe the problem is there....
    Wanne earn something a couple of dollars?
    http://www.gold4email.com/signup.php?r=427
    (^--no minimum pay-out!)
    http://www.CashRoyal.com/cgi-bin/signup.cgi?r=sluarg1@hotmail.com
    Quote Quote  
  3. 18th Dec 2002 04:25 #3
    bugster
    bugster is offline
    Member bugster's Avatar
    Join Date
    Jan 2002
    Location
    UK
    Search Comp PM
    Which version of Tmpgenc are you using. This is typical of 2-pass VBR behaviour. Newer versions show 'analyzing' accross the preview window during this pass. Wait till the progress bar reaches or exceeds 50% and it will start the actual encode.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!