VideoHelp Forum




+ Reply to Thread
Results 1 to 2 of 2
  1. 2nd Nov 2002 23:58 #1
    NES_Master
    NES_Master is offline
    Member NES_Master's Avatar
    Join Date
    Dec 2001
    Location
    Lexington, NC
    Search Comp PM
    Send a message via ICQ to NES_Master Send a message via Yahoo to NES_Master
    Alright, I just bought a Western Digital 80G 7200 RPM ATA100 HD. I figured this would be fine as my capture HD. After installing it on the 2nd IDE channel(odd case design and short cables prevented me from using the primary for both) and tested my machine. I captured over 30 minutes of video without a single dropped frame. When I played it back in Premiere, it looked great, then started to glitch as my old HD was thinking... I made sure everything was on the new 80(relating to the video) but the old 10G still wants to think, which kills the video.

    Is there a solution to this? Both drives are runing in mode Ultra DMA, both are derfaged... I know it's not the computer as it worked fine with my previous tests, when I only had the 10G in it...
    Quote Quote  
  2. 3rd Nov 2002 00:28 #2
    NES_Master
    NES_Master is offline
    Member NES_Master's Avatar
    Join Date
    Dec 2001
    Location
    Lexington, NC
    Search Comp PM
    Send a message via ICQ to NES_Master Send a message via Yahoo to NES_Master
    I THINK I fixed it...but I'm not 100% sure... Basically, I modified the case so both drives could be connected to one channel. So far, it seems to be doing great, even thought I hooked them into the secondary channel
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!