Can anyone Plz tell me why i constantly get poor Audio Sync After following the step by step guide From Divx to Svcd using Virtual Dub to extract the Audio which aparently according to the guide stops this in most cases.Well in my case it hasent time and again most reacantly trying to make a svcd from a divx source having followed the guide extracted the audio cut the film in half encoded it used Nero burner to make the svcd it was out by quite a bit so i used the usual teqnique ive used before of recording several short clips at the same settings and birate wrote down the audio gap change on each clip played them back on the dvd player found the best audio setting plus or minus then went back and encoded at that setting only to find the end result was still out and in some cases by more than a second.Then i guesed from that and re encoded at the estimated setting and hit it on the head assuming this would be the right setting for the second part of the film i set it the same and then played it back on the burned cdr and this part was out by over 9 seconds EXPLAIN that will you someone plz.