problems with vcd easy (aspi)

[ess182]

at the bottom it always says aspi seems valid:no and when i try to burn it says ERROR: Cannot set write parameters mode page. Try to change the driver in using "Force Driver" in the "CDRDAO settings" page
ERROR: Simulation failed.
at the end help!!!!!!!!1

[Digifreak]

Click on the link to the right of the Setting CDRAO "Force Driver" drop-down and determine which driver is correct for your writer, then select that driver from the drop down list. VCDEasy is buggy on CDRAO integration. Sometimes I would get an error, change the driver, get an error, then change it back to Generic-mmc, reboot and presto it works. If you found your writer in the list and have that driver selected but still get an error, keep screwing with it and reboot.

[vitualis]

Please don't post the same question on several forums.

http://www.vcdhelp.com/forum/viewtopic.php?t=118461

Regards.