ES10 passthrough

[lojelo5]

I haven't used this machine for many a year it's been in the loft I actually thought it wouldn't work but I needed to try it with a certain vhs tape I have.

Anyway here is the setup and problem



VCR Panasonic NV-F200 = s-video out to ES10 AV4 in

ES10 = s-video out to Lite-on S-video in

Now this is where I am having trouble I hear sound but no picture

I tried this the other day with a Panasonic DMR-XS350 with no problems at all but I can't figure the connections settings with this machine do I have to use the S video with component for AV1 Output, then set AV2 Input S video with Ext Link 1?

I have tried a few options but I am not getting a picture through at all just sound.

[hdfills]

S-video inn = S-video Out = AV4

[Skiller]

S-Video out from the Panasonic is always active, it doesn't need to be configured. Edit: Except S-Video via Scart on European models.
Do you get see any of the Panasonic's own menus?

[lojelo5]

I can see all the settings inside the ES10

I have a scart in the scart out to the tv could this be causing an issue? I'm downstairs now so will remove it later if this will cause issues.

[Skiller]

Just to make sure, I was asking if you can see the Panasonic's menus via S-Video in your capture, not on the TV via Scart.


It shouldn't cause a problem if there's a TV connected on AV1.

[lojelo5]

Right I'm back upstairs

To start from fresh I set the machine to default settings set it up like normal now I can see the ES10 settings via the S-video but I can only hear the sound and I am getting a grey screen.

Right I have sorted it complete knob head mistake lol I didn't put it on AV4 via the remote what a dick.