The Sharp QC-54 is a vintage camcorder that actually uses a vacuum tube image sensor. But for some reason either the ebay seller or someone who had it before them, cut the cable. Ths problem is these had their cable hardwired in, so you can't just replace the cord. Also it's a special 10 wire cable, that originally had a VERY uncommon connector, a 10 pin Hirose connector designed to connect to vintage camcorder power supplies. Ths single cable contains wires for power in, and video out, and audio out, as well as a pause signal to stop it from recording remotely if connected to a VCR with this special connector instead of a power supply with that connector. That means replacing the cable will require finding a special connector and correct cable. Good luck with that.