The continuing saga that began with Which passthrough devices straighten out the bottom of VHS signals?. I've been meaning to start a thread on this since 2017.
A current discussion in a grave-dug thread has prompted me to post proof of the method. Just a mini write-up at the moment, not a real guide. But this is a simple procedure once you know where to look inside the machine.
With my recent usage of a SAA7133 capture card that can be forced to show the Vertical Blanking Interval, it's now easier to demonstrate exactly what's going on.
[Attachment 51435 - Click to enlarge]
Internal adjustment of VCR potentiometer
[Attachment 51432 - Click to enlarge]
[Attachment 51433 - Click to enlarge]
Panasonic PV-S4670 service manual:
[Attachment 51431 - Click to enlarge]
Our goal here is to intentionally deviate from the spec, so you don't actually need any of the tools/equipment mentioned in the service manual besides the appropriate-sized Phillips-head screwdriver. Unless you want to restore the original setting.
I've only tried a handful of models so far:
Unfortunately, the AG-1980 creates chroma artifacts toward the top of the frame if the HSW point is pushed outside the active image.
- Citizen JVHS3989B (garbage mono VCR)
- Panasonic AG-1980
- Panasonic PV-S4670
Typical JVC VCRs need not apply. They use some sort of auto-adjustment, set with the hard-to-find Jig RCU service remote.
Similarly, the Mitsubishi HS-HD2000U service manual says how to perform the automatic adjustment of "playback switching point". Nothing about how to manually force it.
[Attachment 51491 - Click to enlarge]
(The attached sample is encoded in ULY2 = Ut Video codec.)
+ Reply to Thread
Results 1 to 7 of 7
Last edited by vaporeon800; 16th Jan 2020 at 01:06. Reason: "Size" details of images not functioning; add link to 2017 post that had a couple more screenshots; add HS-H2000U SM snip
I wish capture cards can capture at a flexible resolution that can be set during capture so that the final output when crapped to say 720x480 only clean video will be left. For example if the junk lines are 8 on top and 12 on bottom and 7 pixels on left and 13 pixels on right, the capture resolution will be set to (720+7+13)x(480+8+12) or 740x500 then crap in VDub the values mentioned earlier and you will get clean legal 720x480 output frame.
I'm not sure I understand. Analog tapes will always have blanking on left & right edges at 720x480. The closest standard res is 704x480.
For the vertical direction, DScaler's Vertical Delay option with the special BT8x8 & SAA713x chip support (AFAIK limited to WinXP) lets you line up whichever scanlines you want into your 720x480 output frame.
I think certain Osprey cards using Fusion 878A chips let you perform the same task in their own software with their own drivers.
The reason why I'm bringing this up is because capture devices are still being made most of them are crappy off course but this can be taken into account in a new design to solve the tape based video capture border syndrome, I'm aware of software solutions such as dscaler but I'm talking about hardware solutions at the source.
Last edited by dellsam34; 12th Jan 2020 at 01:14.
Any player that assumes this material was captured according to spec would output an image with a horizontal stretch.
Last edited by dellsam34; 12th Jan 2020 at 04:57. Reason: correction