Harris XD-200 Drivers

[MJB1959]

Hi,
After an extensive search for the drivers for this card, I have given up. I am turning to a couple of forums and see if anyone can help me locate what I need.

I have a Harris XD-200 video card that I am trying to test. I cannot find the drivers. I even searched for the hardware ID under Windows to no avail.

Here is the information on the card:

Harris XD-200
9400-0956-01 Rev E

This was pulled from a working Harris IconStation. I have a hard drive that has the G-Scribe program that this card works with, but I cannot find the drivers in there because I can't even identify the card in the hardware profile. If I install the card in an XP, Vista, or Windows 7 computer, it shows up as an Unknown Device video card. The card has 5 BNC connectors on the back labeled PGM-IN, PGM-OUT, KEY-IN, KEY-OUT, REF-IN. There is also a supplementary sound card hooked through a ribbon cable with 6 BNC connectors labeled CH 1/2 IN, CH 1/2 OUT, CH 3/4 IN, CH 3/4 OUT, LTC IN, LTC OUT.

If anyone has any ideas on where to find the drivers for this, it would be GREATLY appreciated!

Thanks
Mike

[MJB1959]

Here is a little more information....the hard drive that will detect these cards has RTX 1.1. I downloaded RTX 1.4 but it won't detect the card. I am guessing this is because I don't have a USB serial numbered drive....

But that is only a guess.

[october262]

is this the card you have ?? - http://www.ebay.com/itm/Harris-XD-200-Video-Board-9400-0956-01-Rev-E-w-Audio-paddle-bo...-/331680850696

[MJB1959]

Yes. That is the exact same board.

Any idea where to get a driver for this thing?

I can't update the firmware to 1.4 because 1.4 can't see it because there is no driver loaded. The 1.1 software will see it, but I have to uninstall 1.1 to update it to 1.4 and I am hesitant to do that because at least 1.1 acknowledges the card.

Mike

[october262]

and more info here - ftp://ftp.inscriber.com/pub/released/inscriberrtx/15/Documentation/Install_XD200.pdf
and here's another - ftp://ftp.inscriber.com/pub/released/gseries/GSeriesRTXNet/GSeries702RTXNET212/Documen...teFirmware.pdf

[MJB1959]

Yep. Got them.

I might have figured out the issue. I don't think the install program is too compatible with Windows 7. I just installed WinXP on a hard drive and ran the Inscriber program and it found the video card right off the bat. I tried to reinstall under Win7 in XP Compatibility Mode and it wouldn't detect the card.

[MJB1959]

That was the issue. I just installed 1.4 on a clean XP hard drive, I was able to update the firmware on the XD-200 and now it shows up in the Phoenix Control Panel. I'm messing around with it and trying to see if I can get the thing to run under Win7 in XP Mode or something.

[moudit]

hi
hw r u guys
i just want to ask you did you find away to instal XD-200 on win7?
because i have the same problem it's already working on win xp 32 bit but i need to upgrade it.
please if u found how to do it help me.
thank you