Anyone found any way of using the remote web admin interface? Port 8080 gives a 404 when I go there. Tried doing /config etc but just get a forbidden page on anything I tried. If anyone has any experience on these remote interfaces and has any tricks it'd be great.
FYI these are the full TCP ports:
UDP scan is still running.Code:[15:02](root@raven)(~)# nmap 192.168.1.5 -p 0-65535 Starting Nmap 6.40 ( http://nmap.org ) at 2015-05-22 15:02 BST Nmap scan report for 192.168.1.5 Host is up (0.058s latency). Not shown: 65529 closed ports PORT STATE SERVICE 4443/tcp open pharos 7011/tcp open unknown 7676/tcp open imqbrokerd 8080/tcp open http-proxy 8443/tcp open https-alt 15500/tcp open unknown 52345/tcp open unknown MAC Address: BC:14:85:47:93:77 (Unknown) Nmap done: 1 IP address (1 host up) scanned in 33.31 seconds
The remote management option in the settings page generates a pin number so I imagine that finding the correct page on 8080 will have a pin input option.
+ Reply to Thread
Results 1 to 1 of 1
Last edited by slackhead; 22nd May 2015 at 10:20.