TMPGEnc - Resume after error

[Feli]

Hi,

I was almost finished converting an .avi into .mpg with TMPGEnc when an error occured and the conversion stopped (okay, so there wasn't enough space on my hard drive...)
If I hit 'start' again, though, I get the message that the file already exists (of course, since I've already spent 7 hours converting 690MB) and I'm asked if I want to overwrite - which I DON'T, because there are already 690 out of 750MB encoded.
Is there no RESUME option?

[jbrondum]

Feli,

There is no resume option (not yet) in TMPGEnc
...but what you can do, is to change the range being encoded and then join the 2 files.


Regards,
John Brondum

[Feli]

Thanks for the info! How do I change the range?

[Feli]

Feli,

There is no resume option (not yet) in TMPGEnc :(
...but what you can do, is to change the range being encoded and then join the 2 files.


Regards,
John Brondum

Thanks for the info! How do I change the range?

(glad that this forum says newbie conversion...)

[mute]

...but what you can do, is to change the range being encoded and then join the 2 files.

As soon as I use the cutter/joiner in Tmpgenc's MPEGTools Nero (and other burning prgs) complain that it is no longer a standard-compliant VCD.

Is this a known problem, and how can I avoid it from happening?

TIA

[KingJohn]

Make sure you change the drop down arrow to Mpeg 1 VCD, before you hit run

[mute]

Make sure you change the drop down arrow to Mpeg 1 VCD, before you hit run

[Blushing in shame]
Should have seen that!


Thanx!

(

(glad that this forum says newbie conversion...)

So am I...
)