How Do I Make a P-Size Switch on Samsung LN46A650A1FXZA

[hammec]

I occasionally use my Samsung television as a computer monitor. To get the display from the computer to fit the screen I have been using the P-Size button to switch from 16:9 to Just Scan. When I select Just Scan, the picture fits fine, but after about an hour it switches back on its own to 16:9, which clips off the edges of the picture. How do I get it to stay formated for my computer.

If this is the wrong forum, or not an appropriate question for this community I appoligize. I found this forum when I was doing a search for the answer. Thanks in advance for any help.

[jagabo]

I have an older Samsung model and it doesn't have that problem. It stays where I put it (just scan, 16:9, etc). I would check for a firmware update from Samsung.

You might have better luck finding information here:
http://www.avsforum.com/avs-vb/showthread.php?t=1007540

[hammec]

Thanks for the reply. I looked over that thread and did not see anything about my problem.

I know how to update drivers, software ect on a computer, but don't have a clue about how to update firmware on a television.

[jagabo]

I know how to update drivers, software ect on a computer, but don't have a clue about how to update firmware on a television.

It's pretty easy but you'll have to check the specifics of your TV. In general, you download the file, put it on a USB thumb drive, then put the drive in the USB port on the TV. You may have to navigate through the menus and elect to update the firmware.

[hammec]

Thanks. Sounds simple enough. I had visions of myself with a magnifing glass and soldering gun.