TMPGEnc2.50 get only (35min) decoding!Why?

[SKeeper]

Hi,all!
I use TMPGEnc2.50 and would like to convert 3GB-mpeg (1 h.30min) _file in SVCD as usual, everything is OK, but everytime TMPGEnc2.50 get only (35min) decoding!
It wasn't into early TMPGEnc-versions so, would always to decode 3GB or 4GB or 5GB like whole one made!

What must I change, thus whole film be decoded?

Thanks
SKeeper

[jasond]

copy the templates from the plus version to the folder you use and select the wizard (gives a few choices then) or check your pm for a link to get the plus

[Antonio S.]

SKeeper:

I discover that since version 2.5x, TMPGEnc has a min default value of 2000 Kbps when encoding with VBR. This will increase your encoded file about 30-60 % depending on the template use. So I recomend you to use previous versions...

Antonio S.
http://www.antonio.owns.it

[SKeeper]

thanks,i get it!

SKeeper

[SKeeper]

doesn't workig for me!!!
perhaps there is extra adjusting for this?

identical, which TMPCmt version is now,so it makes only 30 min decoding of all from 1h 30min Film!

What can i do?

Thanks
SKeeper

[SKeeper]

doesn't workig for me!!!
perhaps there is extra adjusting for this?

identical, which TMPCmt version is now,so it makes only 30 min decoding of all from 1h 30min Film!

What can i do?

Thanks
SKeeper

[SKeeper]

Hi,all!
perhaps have I printed wrongly what I want!

I will to try once again with my question, so (I have 2 different Mpeg2 files,(this mpeg2-files was made with mine Sat-digital Receiver Nokia9600scsi)

first mpeg2 file is- 3.07 Gb,
second mpeg2 file is- 3.05 Gb

wenn i load first-file with TMPGnc2.02, there in Programm, where stand:

Progress
Whole -------------------0%------------------------- 0 / 138235

this 138235 it is OK!
and will decoded to
SVCD a 100%
whole 1h 30min film!


But wenn i load second-file, there is only stand so:

Progress
Whole -------------------0%------------------------- 0 / 44548 ?????
hier is only 44548?
and will decoded
only 30min from
whole 1h30min
Film!


Question is: why almost at two like files, one not goes correctly?
Please, any solution?

RGRDS
Skeeper