Whats the deal with this error message???

[GregTheRotterius]

Any ideas? Im not sure whats going on here, Unless when i did put the ide cables (a seperate cable for each of my two burners) back into the board, i put them into the wrong slots, opposite to how they were before, what do you reckon>?



I've tried enabling and disabling the 'media change notification' but its still telling me invalid parameter. Any ideas?

[Krispy Kritter]

I can't see the error message. Are the drives recognized in the BIOS? Are they recognized by windows? Any yellow ! marks in device manager.

[Bjs]

That message can be suppressed in the options

Tools > settings > device tab .
Down to the lower left ... check the box and try again .

-------------------

Swapping cable's about ...

If both drive's are sharing a cable , the one that is connected to the very end should be set as master , the other as slave ... via the jumper's .

Alway's check those jumper settings on the back of drive's .

------------------

Ripping dvd ?

Try PgcEdit_install.exe

Go here for the installer that install's the psl2 plugins : http://forum.digital-digest.com/showthread.php?t=58318

You will want the last dvddecrypter , dvdshrink , and imgburn .

Handle's the new protection's used .