PGCEdit and Layer Break Setting

[edsmith77]

To All,
A while back there was a thread concerning setting the layer break for DL disks using PGCEdit and DVDDecrypter. Unfortunately, I cannot seem to locate that specific thread.
My question regarding setting the layer break is:
1. If the disk is a full DL then it is obvious where the break should go. However,
2. If the disk is not a full DL, then should the break go at the max extent of layer 0 and then leaving a big section of layer 1 unused or should it go at the extent that is say 1/2 way of the movie? Thus, leaving a portion of layer 0 unused and approximately the same amount for layer 1 or
3. Most likely put the break at some point that is convient with respect to the movie. regardless of the remainder of layer 0 and 1. If this is the answer, then how does one convert running time in the movie to sector address on the disk. Which is what I think is needed in order to specify a layer break position?

Any help or guidance is greatly appreciated.

[VegasBud]

This guide should help you. "STEP 7 – SETTING THE LAYER BREAK" is the part you're interested in.

[edsmith77]

VegasBud,
Thanks. I think that is exactly what is needed. I will play with it tonight and get back if there are any problems.

Once again, thanks.


Ed