VideoHelp Forum
+ Reply to Thread
Results 1 to 3 of 3
Thread
  1. 19th Dec 2001 04:54 #1
    andyrau
    andyrau is offline
    Member
    Join Date
    Dec 2001
    Search PM
    hi,
    i am using the trial version of ULead DVD Authoring tool to create an SVCD. i used TMPGEnc to encode the DivX file to Mpeg2 format. then i used the MPEG Cut in TMPGEnc to cut the movie. then after creating the menus and chapters using ULead, when it finally reaches the burn screen - it simulates about 98% of the burn process and then it puts up the message box which says drive not ready !! i'm using 700MB - 80 mins CD-R. please help me out as to why i'm getting this error - i tried 4-5 CDs and i get the same message.

    thanx,
    andyrau
    Quote Quote  
  2. 19th Dec 2001 04:58 #2
    EricB
    EricB is offline
    Member
    Join Date
    May 2001
    Location
    Eric
    Search PM
    andyrau:

    Change from the default Ulead burning software to NTI. This is a selection button on the start burning screen.
    Quote Quote  
  3. 20th Dec 2001 00:30 #3
    andyrau
    andyrau is offline
    Member
    Join Date
    Dec 2001
    Search PM
    thanx a lot eric - it worked !!
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!