Ulead Workshop 2 Problems

[spoonbled]

Hi

This is my first post
Very much a newbie to dvd recording.
I have been trying to put some footage onto dvd. So far i have taken the footage from the pal vhs tape, copied it onto disc via my pioneer dvd recorder. I did it in video mode then i have transferred it onto my computer through workshop2

All up it comes to 4.2 GB

Menus etc are not a problem. 2 problems i have found:

1). My recording was 1 conitinuous clip. when workshop breaks it down
example (050603-001 and 050603-002 etc) and when play it back (either previewing or after burning ) there is a pause between each and i lose a second or so of footage/audio.

2). I have still tried to burn this to a single layer disc just to see how it goes. I have a dual layer lite on burner. Problem is 3/4 of the way through the audio is out of sync about a second or two. On workshop with the preview there is no out of sync happening.


Any help would be very appreciated

[unclebud]

I would rip the DVD to the hard drive first (may help sync).

[spoonbled]

What programs do people suggest to do this.

Thanx

[unclebud]

DVD Decrypter or DVD Shrink will rip DVD's to your hard drive. Shrink can also be used to resize the DVD files so a 7 or 8gb dual layer DVD will fit on a single layer DVD - or +R disk.
Check the Tools section of this site.