View Profile
View Forum Posts
Private Message
This is basically a continueation of my last thread("Audio selection in DVD-Lab"). I have a Menu with buttons 'Japanese' and 'English'. Jap is set to "Set Audio 2" and Eng is set to "Set Audio 1". During testing i select Japanese but it never loads the Audio stream, however the English stream(Audio 1) works flawlessly.
Heres the setup:
http://img240.exs.cx/img240/1678/setupmovie6nw.jpg
http://img240.exs.cx/img240/9307/setupmenu3bi.jpg
Any help would be greatly appreciated
+ Reply to Thread
Results 1 to 5 of 5
-
-
I noticed your audio streams are not the same length -- could that have anything to do with the problem?
George -
I doubt it, its only a 5 second diffrence. Thanks
-
And both of them are 4 minutes longer than the movie?
Did you apply the DLP Updates? One of the updates lists this item:
<<<
Missing audio in last VTS movie may set no audio for whole VTS
>>>George -
No i didn't apply any updates. None that i know of at least. Il check it out thou. Thanks
Quote