audio

[ribac]

I compiled my project,when played in Power DVD everything is fine.
Put it in my standalone DVD player audio doesn't play.
I used mp2 file.Tried to convert to AC3 in ffmpegGUI but strange think happened after clicking Convert,nothing had been convert.Don't know why.
Anyway left it as mp2 but audio doesn't play.

[Baldrick]

have you tried changed the audio settings in your dvdplayer? usually under audio and to output mp2 as pcm audio.

you can also try convert to ac3 with belight or besweet.

[MpegEncoder]

I compiled my project,when played in Power DVD everything is fine.
Put it in my standalone DVD player audio doesn't play.
I used mp2 file.Tried to convert to AC3 in ffmpegGUI but strange think happened after clicking Convert,nothing had been convert.Don't know why.
Anyway left it as mp2 but audio doesn't play.

ffmpegGUI works fine. Are you missing something? Like the output filename?

[reboot]

In ffmpeggui, always use the browse button, give your file a name that ends in .ac3 and then click OK, then Convert.

[ribac]

I did it in fffmegGUI many times but this time I set output file,input file,hit convert and I get a message righ away "finished"and file doesn't even exist.

[guns1inger]

Not all NTSC players will play mpeg audio. Not all amps will either. If you are playing through an amp, make sure your player sends out a PCM stream for mpeg audio.

[reboot]

Where did you get the original mp2 file?
I would load it into virtualdubmod, select streams, stream list. Right click the audio stream, select full processing, then Save .wav.
Load that .wav into ffmpeggui and transcode.

[ribac]

Original .mp2 igot from DVD Lab.
When demux MPEG2 I got to files .mpv and .mp2.

[GeorgeW]

agree with guns1inger -- could just be that your dvd player isn't playing the mpeg audio. is it an NTSC disc, or are you going through an amp?