VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 19th Nov 2004 13:02 #1
    notbothered
    notbothered is offline
    Member
    Join Date
    Oct 2004
    Search Comp PM
    Hi
    After i have specified the audio and video files, set my source range, and when i press START to encode i get the following Error

    "Index of scan line is out of range(272)"
    Quote Quote  
  2. 19th Nov 2004 15:11 #2
    daamon
    daamon is offline
    Member daamon's Avatar
    Join Date
    Jun 2003
    Location
    Melbourne, Oz
    Search Comp PM
    Hi notbothered,

    If it's the same file that you were using here then it's probably because it's a defective source file.

    Re-rip it from the DVD again, convert to Xvid again and then see if that's OK....
    There is some corner of a foreign field that is forever England: Telstra Stadium, Sydney, 22/11/2003.

    Carpe diem.

    If you're not living on the edge, you're taking up too much room.
    Quote Quote  
  3. 19th Nov 2004 17:07 #3
    Laddydaddy
    Laddydaddy is offline
    Member Laddydaddy's Avatar
    Join Date
    May 2002
    Location
    Philly
    Search PM
    Hello notbothered,
    Try scanning for bad frames. There is a guide at https://www.videohelp.com/forum/userguides/153907.php. See if that helps.
    It doesn't matter who you vote for. The government always gets in.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!