VideoHelp Forum

Try DVDFab and download streaming video, copy, convert or make Blu-rays,DVDs! Download free trial !
+ Reply to Thread
Results 1 to 4 of 4
Thread
  1. Member mar-mar's Avatar
    Join Date
    Mar 2003
    Location
    between here and there
    Search Comp PM
    i've been readin up on firmware little bit thru the site and all but im a little confused. im using a nec -nd1000a dvd+rw drive and flashed with 1.01 but now the dvd plays but i can't burn cdr or dvdr properly it would go to about 50% complete and then terminate burn or i would burn on a lower speed where it would finish succesful but the disc would be trash , i did a simulate test and that works perfectly to 100% succesful but just doesn't on actual, can firmware or say bad flashing be a cause of this or could the burner be shot
    http://www.dondivamag.com
    :) This site is the Best thing since slice bread :)
    Quote Quote  
  2. Member mar-mar's Avatar
    Join Date
    Mar 2003
    Location
    between here and there
    Search Comp PM
    im stuck at this point ,what do i do?
    http://www.dondivamag.com
    :) This site is the Best thing since slice bread :)
    Quote Quote  
  3. Member
    Join Date
    May 2003
    Location
    Manchester, England
    Search Comp PM
    If it was fine until you upgraded your firmware, I'm pretty sure that's most likely the problem.

    Can you downgrade it?
    Quote Quote  
  4. I would say re-install the firmware without a disc in drive and see if that fixes it.
    Quote Quote  



Similar Threads