DVD Decrypter Question

[Rafael]

I am trying to back-up finalized discs I burned on my Panasonic E80 using DVD Decrypter. I have ran into the following problem. In ISO Read mode, the process starts to fail somewhere after 90%. If I abort the process at that point and save the "incomplete" ISO, I can burn it normally into a DVD using the ISO Write mode in Decrypter or just the burning engine in Nero. My impression is that the ISO reading process chokes as soon as the end of the data section in the original disc is reached, even though it's been properly finalized (writing of "emptier" discs fails earlier than that of "fuller" discs). Why is this happening? Do I need to change my decrypter settings? I have tried it with all kinds of media and the same thing always happens. Any help will be appreciated.

[noki]

dvd decrypter's ISO Write function is known to have problems, esp. when burnproof is used. this has been the case from v3.16 on. i would just burn the image with Nero. also you have some contradicting statements in your post. might want to edit it.

In ISO Write mode, the writing process starts to fail somewhere after 90%...I can burn it normally into a DVD using the ISO Write mode in Decrypter

[Rafael]

So if I uncheck Burnproof would the problem go away?

[noki]

don't know...try it on a dvdrw. good luck.

[Rafael]

LOL, you're right. I contradicted myself. I meant to say that the failure is on ISO Read mode. I edited it. I'll try to do it disabling the Buntproof and see what happens.