tmpgenc

[hassali]

hi, i've read through the tmpgenc problems page but still couldn't find a solution.

Every time i start up the wizard and go through it, when i select DVD, and load the file etc. At the last point, where it says output file, for some reason it is always selected as output as individual streams i.e m2v and wav??
I dont want it as two streams, and i cant change that setting. Ive tried using the unlock template but doesn't work either.

This has only occurred recently coz before i could encode and the output would be a single mpg file.

Any help would be greatly appreciated

thanks

[Tommyknocker]

[teegee420]

Does your version of TMPGEnc have this option in the project wizard?

If so than uncheck it.

[hassali]

yes, my version does have that option, but i'm unable to uncheck it. It becomes grey and i'm unable to change it.??

[teegee420]

You might want to disable the project wizard then and just load the DVD template from program directory. Make sure your settings are as pictured in Tommyknocker's post. If it is grayed out then load the ulock file.

[Craig Tucker]

You need to select the audio to be encoded to mpeg1 layer II, an m2V and a PCM wav cannot be multiplexed that is why they are output as seperate files. I think with the later version of TMPGEnc you can select the audio to be output as LPCM and this is probrably what you have done, is the wav file very large. If you select MP2 for the audio you can select to output the audio and video stream together as an mpg file.

[hassali]

that was it !!! thanks craig !

I changed the audio to mp2 and problem solved.

Thanks again for the help

[Craig Tucker]

No problem