I saved a project to DVD Movie Factory 2. I just about finished it, until recently I bought Pinnacle Studio 8. Then I tried to open the project and it started to load, but then it just stopped. I looked at the hard drive light and that had stopped doing anything. I could start the project all over again, but I already put a lot of work into it (i made a lot of slide shows.) I tried opening smaller projects, and those opened just fine. I did recently put a new hard drive in (200 gb), but it saves everything to my current hard drive which is almost full. What could I be doing wrong? (I tried switching the hard drive to the new one, but I am not sure if I have to switch it in more than one area.)