VideoHelp Forum




+ Reply to Thread
Results 1 to 2 of 2
  1. 3rd Sep 2003 00:06 #1
    ChachiFace
    ChachiFace is offline
    Member ChachiFace's Avatar
    Join Date
    Jun 2003
    Location
    NTSC Land
    Search Comp PM
    I've been using TMPGEnc Plus for a while now and haven't had any issues until now. I recently encoded an AVI file into 2 elementery streams using TMPGEnc, M2V and WAV. I realized that I had the bit rate set too high so I deleted the files and went back to re-encode the original AVI file. When I try and open it up in either a new project or the project wizard, I get the following error:

    File "H:\DV-CAPTURE\movie-intro.avi" can not open, or unsupported.

    Can someone tell me what I'm doing wrong? I've re-encoded AVI files before without this issue.

    Thanks in advance,

    ChachiFace
    Quote Quote  
  2. 3rd Sep 2003 00:45 #2
    ChachiFace
    ChachiFace is offline
    Member ChachiFace's Avatar
    Join Date
    Jun 2003
    Location
    NTSC Land
    Search Comp PM
    Nevermind. I found out what the problem was. I recently uninstalled some Pinnacle software that I was using along with the Premiere that I'm running. I guess I needed it cause when I re-installed it, the files were accepted by TMPGEnc once again.

    ChachiFace
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!