VideoHelp Forum




Results 1 to 2 of 2
  1. Been using VCD Easy for about 6 months now on my Win XP system (Athlon 1000, 384mb, 120gb hard drive). I grab through my Hauppage card using VirtualDub, then convert using TMPGEnc. I then use VCDEasy to put Chapters in before burning to VCD.

    Last night, I tried to do this with an mpeg I created exactly the same way as I've described above. The mpeg checkwent fine, but when I came to start the Chapter process, when I hit the button to mark in the first chapter point (i.e. at 0.00) I got a 'Floating Point' error message on screen, and I cannot set any chapters.

    Anyone got any ideas??

    Many thanks

  2. Just a follow up to my message below.

    I tried again when I got home tonight, still the same problem.

    Thinking it may be a fault from the avi-mpeg conversion, I tried on an old mpeg that I've already put chapters on, and that was the same.

    I uninstalled VCD Easy and then re-installed it-same problem.

    I uninstalled VCD easy again and tried a previous version-same problem.

    It's not like I've added any other software or changed any ocnfiguration. Yesterday morning it would let me create chapters, now, as soon as I hit the button to set the opening point for the first chapter, i get this Floating point division by zero error.

    Anyone got any thoughts at all??




Similar Threads

Visit our sponsor! Try DVDFab and backup Blu-rays!