VideoHelp Forum




Results 1 to 6 of 6
  1. Guest
    Trying to build a SVCD I always get the same output:

    **ERROR: EOF in WAV header
    **ERROR: failure reading WAV file
    INFO: [mplex] mplex version 2.2.1 ($Date: 2002/04/20 19:08:30 $)
    INFO: [mplex] File /Users/kermit/Documents/test.m2v looks like an MPEG Video stream.
    **ERROR: [mplex] Unable to open file /Users/kermit/Documents/test.mp2 for reading.

    The result should be a .img but is a .m2v only.
    Where's my fault?

    Any ideas?

    Martin

  2. Specify the audio track number (depending from the track number in the source VOB).

  3. Guest
    Aaaaaaaaaah!

    You took me on the right lane.

    0SEx told me audio track would be 1, but obviously it was 0.
    I tried and it worked.

    thx for superfast answer.

    Martin

  4. idk
    Guest
    get the same error message (EOF in WAV header).
    how do I find audio track?
    when I click 'check' in ffmepg, get applescript error
    Thanks
    idk

  5. Use N-1 where N was the number shown in 0SEx for the audio track.
    The "Check" button works only with an AUDIO_TS folder as input.

  6. idk
    Guest
    ++ WARN: [mpeg2enc] 3:2 movie pulldown with frame rate set to decode rate not display rate
    ++ WARN: [mpeg2enc] 3:2 Setting frame rate code to display rate = 4 (29.970 fps)
    ++ WARN: [mpeg2enc] Generating dummy SVCD scan-data offsets to be filled in by "vcdimager"
    ++ WARN: [mpeg2enc] If you're not using vcdimager you may wish to turn this off using -d
    a52dec-0.7.4 - by Michel Lespinasse <walken@zoy.org> and Aaron Holtzman
    No accelerated IMDCT transform found

    0 frames decoded in 0.00 seconds (0.00 fps)
    **ERROR: EOF in WAV header
    **ERROR: failure reading WAV file
    INFO: [mplex] mplex version 2.2.1 ($Date: 2002/04/20 19:08:30 $)
    INFO: [mplex] File /Users/idk/Desktop/DVD_SVCD/cb2.m2v looks like an MPEG Video stream.
    **ERROR: [mplex] Unable to open file /Users/cassianyee/Desktop/DVD_SVCD/cb2.mp2 for reading.

    Well,
    the audio track from OSex says "1 Normal Audio (EN) [AC3 2CH DRC 44 KHz]" so I set Audio track to N-1 = "0".
    but I still get the above errors?

    your thoughts?
    Thanks,
    IDK




Similar Threads

Visit our sponsor! Try DVDFab and backup Blu-rays!