Hi,
just wondering if anyone can help me.
i have a windows 7 pc Acer AX330
Driver HL-DT-ST Gh14N
I was burning few disks with out no problem then it just crached on me,
At first i was unable to locate the drive it vanished, so i went to the windows fix it downloaded a fix it too from microsoft for this error and it located my drive. however when i open IMGBURN UP its stuck on "locating SCSI / ADPT devices"
In the windows reporting error in event reviewer it says error "The driver detected a controller error on \Device\CdRom0.
so uninstalled the drive, restarted and it installed and imgburn came back up. within afew minutes it just froze so i went to my computer and if i touch the drive by right clicking it freezes explorer.
i currently get this error in The device, \Device\CdRom0, has a bad block. since reinstalling. & stuck on "locating SCSI / ADPT devices"
any advice?
thank you x
Try StreamFab Downloader and download from Netflix, Amazon, Youtube! Or Try DVDFab and copy Blu-rays! or rip iTunes movies!
+ Reply to Thread
Results 1 to 2 of 2
Thread
-
-
may be a loose/bad data cable. or the drive is dying.
--
"a lot of people are better dead" - prisoner KSC2-303
Similar Threads
-
Advice required when trying to burn with img burn
By IPBR21054 in forum SVCD2DVD & VOB2MPGReplies: 4Last Post: 1st Aug 2009, 16:29 -
IMG Burn says - File too large!
By orfajackson in forum Newbie / General discussionsReplies: 6Last Post: 26th Jul 2009, 13:41 -
Writing fail with Img Burn
By anfield7 in forum Newbie / General discussionsReplies: 7Last Post: 7th Feb 2009, 04:02 -
I/O Error in IMG Burn - Help!
By msdker in forum Newbie / General discussionsReplies: 7Last Post: 21st May 2008, 23:11 -
Which is best to burn - img, iso or video_ts
By dynamique in forum Authoring (DVD)Replies: 10Last Post: 29th Sep 2007, 14:13