VideoHelp Forum
+ Reply to Thread
Results 1 to 3 of 3
Thread
  1. 9th Jan 2020 11:05 #1
    Maja
    Maja is offline
    Member
    Join Date
    Jan 2020
    Location
    Peru
    Search Comp PM
    Hi, I just connected an old SVHS Panasonic AG 5700 after not using it for some time and I only get a message on the small screen "sensor". Nothing else turns on. Should something else turn on when pressing power? Thank you.
    Quote Quote  
  2. 9th Jan 2020 14:09 #2
    orsetto
    orsetto is offline
    Member orsetto's Avatar
    Join Date
    Oct 2007
    Location
    NYC
    Search Comp PM
    There is a switch on the top left of the rear panel labeled "SENSOR REC" - if it is in the ON position, turn it OFF.

    You should then be able to use the VCR normally.

    The SENSOR REC mode puts the 5700 into a sort of recording standby zombie state, waiting for the signal from a compatible source to automatically trigger start and stop of recording.
    Quote Quote  
  3. 9th Jan 2020 20:00 #3
    Maja
    Maja is offline
    Member
    Join Date
    Jan 2020
    Location
    Peru
    Search Comp PM
    Thank you very much Orsetto. Will try tomorrow.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!