VideoHelp Forum
+ Reply to Thread
Results 1 to 5 of 5
Thread
  1. I've just been converting a .avi movie to a .mpg, and ran out of disk space. I have cleaned up lots now and the movie is at 85%. However, this took me over 8 hours to get there and i don't fancy restarting. The bar is still at 85%, and I can see the video stream (paused). The elapsed time has also stopped.
    When I clisck start, it asks me if i want to overwrite the file. Please help me out here, I have TMPGEnc still runnung!!
    Quote Quote  
  2. Guest
    Unfortunately not
    Quote Quote  
  3. Damn!! thanks anyway mate................
    Quote Quote  
  4. You cannot directly, However, it is possible if you specify the frame number in source range, you can then continue from there.
    Computers
    Quote Quote  
  5. As Chris X said ...

    - Make a note of the framenumber your have stopped on
    - The partial mpeg should be saved on your HDD
    - When you have the required space free on your HDD start encoding again but in Source Range specify the frmae number you wrote down as the start
    - Once this portion has been encoded you can use the MPEG tools Cut and Join section to join the two mpegs
    Quote Quote  



Similar Threads

Visit our sponsor! Try DVDFab and backup Blu-rays!