How to loop a single video to a set time duration?

[mikeyb81]

Hello everyone,

I just downloaded and installed Clever ffmpeg GUI. What is the easiest way to loop/extend one video to a set time duration?
For ex: If I wanted to make a 5 minute video loop for 3 hours so it would be a 3 hour long video. How would I loop/extend that 5 minute video 36 times with lossless quality?

Thanks for everyone's time and I hope this post finds everyone well.

[jagabo]

With the command line:

ffmpeg -stream_loop 36 -i input.mp4 -c copy output.mp4

[mikeyb81]

Thank you very much jagabo. That worked. Do you know how I would create a fade out offset and a fade in offset of a looped video?
For example, in Vegas Pro, I can copy and paste the same video in a project (looping). So I have the same video back to back. I move the 2nd copied video backwards a bit so it's about 2-3 seconds on top of the first video and I do a crossfade from one to another. This works really well. Is there a way to do this in ffmpeg?

Thanks again for your time. I really appreciate it

With the command line:

ffmpeg -stream_loop 36 -i input.mp4 -c copy output.mp4

[jagabo]

Loop with crossfade is much harder. I might have time to figure it out this weekend.

[videoAI]

You probably need a full video editor for cross fade transition, which ffmpeg is not.
but you can easily do start and end video and audio fades easily in ffmpeg or easier
yet in clever FFmpeg-GUI.

I move the 2nd copied video backwards a bit so it's about 2-3 seconds on top of the first video
and I do a crossfade from one to another. This works really well.
Is there a way to do this in ffmpeg?

[jagabo]

ffmpeg's xfade supports crossfades in addition many other transitions. The difficulty is getting the commands right for 36 copies of the clip.

This could also be done pretty easily in AviSynth.