How do I get CDRDAO out of "test" mode?

[E]

Installed VCDEasy, and enabled CDRDAO. Everyting works fine except the whole thing runs in test mode. The CD spins, the light goes on oand the buffers flo and ebb, and when the whole circus is over, nothing was written, Happily exiting with "TEST SUCESSFULL". How do I get the darn thing to actually *burn* the CD?

[druss2001]

I ran into this problem also . I looked at the program again and there is a check box called 'burn' (I believe). This was located to the right of the box where you select the file name.

Once I checked this, the program burned the CD after the test stage.

I can't go into specifics of where this box is because I had to uninstall the program since it kept interferring with Nero and the LSI ASPI drivers that I have installed.

Dave