cannot cut fresh svcd made with TMPGE with TMPGE ?

[TasDavo]

Hi guys, just made a 2.1 Gig MPEG2 file from an AVI. I had planned to span it accross 3 disk but when I open up merge and cut through TMPGE/MPEG TOOLS, (I selected MPG2 super vidCD(VBR), when I converted I used CBR worked out with a bitrate calc) And add the source stream to it, double click to get the range window, it does not display start or finish times, and I cannot seem to set the cuts that I want in the range window(approx 38mins per CD) can any one help with this problem, is it a TMPG problem, is there another easy to use cutter like TMPGE out there? any advice would be greatly appreciated.
Cheers in advance Dave.

[N0SoopForU]

Hmm, I've never used TMPGEnc for cutting MPEG-2 files, but I hear it sucks. I rarely cut MPEG-2 files, but when I have to I use M1-M2 Edit (See "Tools" section on left). I think you will get better results using it over TMPGEnc.

[Ronin2]

Go into the Tools section, there is a n MPEG2 Plugin for TMPGEnc. You will have to install it to cut MPEG2 files with TMPGEnc.

Regards,
Ronin2

[lee mu bai]

use mpeg-vcr. it's listed under Tools.

[TasDavo]

thanks guys for the replies, as I posted this I looked further down the page and noticed a guy with the same problem. The advice was to use bbmpeg to cut, and having tried it now I swear buy it, I'm not suffering from lip sync problems as I have with other programs. I strongly recommend it.
Cheers all
Dave