ATTN RIPPER---- PLEASE READ

[mp3upforlife]

Hey man, ca u check out this error message and let me know what u think is wrong?

i try to burn this MPEG file and i get tons of error messages in VCD Easy....heres info on the file from ISO Buster:

File: 811 MB (0.0 B), duration: 0:00:00, type: MPG, 1 audio stream(s), quality: 88 %

Video: 0.0 B, 2530 Kbps, 29.970 fps, 480*480 (16:9), MPG2 = MPEG 2 (SVCD/DVD), Supported

Audio:0.0 B, 192 Kbps, 44100 Hz, 2 channels, 0x51 = Mpeg-1 audio Layer 2 [0xc0], Supported


Error from Vcd Easy: i take the MPEG file and try to burn it under VCD easy for a SVCD...heres the errors that i get:

changed volume number to 1
changed volume count to 1
changed restriction number to 0
changing 'next volume use sequence 2' to 0
changing 'next volume use lid 2' to 0
changed volume label to `SUPER_VIDEOCD'
changed publisher id to `VCDEASY_V1152'
changing 'update scan offsets' to 1
changing 'relaxed aps' to 0
adding pbc (Selection-000/2)
adding pbc (Selection-end/3)
sequence count 1
adding sequence #0, J:\potc.disk3.mpeg
pts start offset 0.230044 (max pts = 3137.071244)
playing time 3136.841200
scanning mpeg sequence item #0 for scanpoints...
already scanned... not rescanning
pbc: psd size 56 (extended psd 0)
iso9660: highest alloced sector is 234 (using 300 as isosize)
generated image (366924 sectors [81:32.24]) may not fit on 74min CDRs (333000 sectors)
OGT streams available: 0 0 0 0
writing track 1 (ISO9660)...
'update scan offsets' option enabled for the following tracks!
writing track 2, MPEG2, NTSC 2/3 D-1 (480x480/30fps), audio[0]: l2/44.1kHz/192kbps/stereo ...
non-MPEG1 audio stream header seen
non-MPEG1 audio stream header seen
non-MPEG1 audio stream header seen


it will continue to say tat and than this comes up

ERROR: Drive does not accept any cue sheet variant - please report.
ERROR: Writing failed.


wat does nnon-mpeg 1 audi ostream header seen mean? how can i fix this? thanks man and major props to helpin me out

[ZippyP.]

Try remultiplexing your mpeg with TMPGEnc. Use the mpeg tools>simple multiplex, drop your file in and select an output destination and name, and be sure to select type mpeg2-Super video CD. That might correct the file header.

BTW, it depends on your machine but it should only take a few minutes.