CloneDVD2

[pepegot1]

CloneDVD2 problem

I tried to send, the below, via email- "support@elby.ch." but, the address they give is nonexistent.

Perhaps, you may have some ideas as to the cause.



AnyDVD is in use during the following:

1. I backup a DVD, and after the reading cycle is over and the writing cycle starts, I get the "Oh! No Error"- stating a media problem.
2. I now use DVD Shrink to rip the DVD to HD and burn back to the Pioneer DVR- 115D Burner. No problems-the copy is perfect. Firmware of Pioneer is 1.18 and Version of CloneDVD2 is 2.9.1.7

If I use CloneDVD2 and burn to my Plextor 760A Ver 1.07- no problems occur. Is it the Burner or the software?
My thought is the Burner, as Pioneer can be slow to recognize media but, this should not be a problem.

[aedipuss]

you probably need to leave of the last "." it's just a period at the end of the sentence on the support page.

use imgburn to write the dvdrs.

[ricoman]

The slysoft.com forum has a CloneDVD2 thread. Go there for any questions. They are very helpful and they are associated with Elby.