VideoHelp Forum




+ Reply to Thread
Results 1 to 3 of 3
  1. 12th Dec 2007 01:07 #1
    mshuang
    mshuang is offline
    Member
    Join Date
    Dec 2007
    Location
    United States
    Search Comp PM
    Trying to put this desktop together, and I wanted to know if I'll have problems trying to install an ide dvd burner with a sata harddrive? In my diagram that comes with the dvd drive, they have both the dvd drive and the harddrive connected to the motherboard via an IDE cable? Should I be setting the DVD Driver as cable select, slave, or master. Thx very much!
    Quote Quote  
  2. 12th Dec 2007 01:46 #2
    johns0
    johns0 is offline
    I'm a Super Moderator johns0's Avatar
    Join Date
    Jun 2002
    Location
    canada
    Search Comp PM
    Connect hdd on sata and have it boot up first in bios and dvd as master on the pata.
    I think,therefore i am a hamster.
    Quote Quote  
  3. 12th Dec 2007 01:46 #3
    budz
    budz is offline
    DVD Ninja budz's Avatar
    Join Date
    Jan 2003
    Location
    In the shadows.....
    Search Comp PM
    how many ide connections do you have on the motherboard? if you only have 1 then just connect the dvd burner to it and set to master. also set the jumper to master on the dvd burner. as for the sata hard drive it should be connected to the sata connector on the motherboard. there should be no problems as the ide dvd burner and sata hard drive will not be connected together on a cable.
    Quote Quote  



Similar Threads

« Previous Thread | Next Thread »
Visit our sponsor! Try DVDFab and backup Blu-rays!