I recently got my the other day, and have been trying to set it up to change channels on my cable box. I've ran the IR Blast config, and it hasn't found a code for it. Plus, I could find any information, for this kind of box, on its IR. I was wondering if anyone may already have the code, or may know how to set it up. Thanks.
Cablebox: Comcast Xfinity RNG 150N (Model PR150BNC)
Programs: WinTV (Version 22.214.171.12412) and its IR Blaster Program (Version 7.3.28312)
+ Reply to Thread
Results 1 to 3 of 3
Last edited by reikitsune; 20th Aug 2013 at 14:26.
Been a while since I set up my PVR using the Hauppauge 1950, so I may not be much help. I can tell you that WinTV is up to version 7.2, but I don't know if that has anything to do with the problem. Your Blast Config is the correct version. I have Verizon FIOS which is relatively new compared to some of these products. I seem to remember I had to 'teach' the config software my remote. I don't think it downloaded the remote codes from Hauppauge. Your problem may be similar.
--dES"You can observe a lot by watching." - Yogi Bera
I never could get that damned IRBlaster to work with my Comcast (motorola) cable box.
I wish you luck, but you know, strictly speaking it's not necessary. I've gotten along fine without it for several years now, and I'm on my second Hauppauge HD-PVR (second one a warranty replacement).Pull! Bang! Darn!