Error code E01 or E02 in Pioneer DVR-x50H/LX60

[Hkan]

SYMPTOM:
Indicate E01 or E02 on the FL display.
Does not operate with indicated "POWER ON" on the FL.
The recording and playback of HDD does not work.

CAUSE:
The malfunction of the SATA cable

REMEDY:
Replace the SATA cable, when you face this problem of HDD.
Replace it even if you cannot confirm a actual symptom
You may change this cable with any that is sold in a computer hardware shop.

* If "E2" has appeard on the FL after replacing the SATA cable, you should perform the initialize of HDD

DVR Models:
DVR-450H
DVR-550H
DVR-555H
DVR-650H
DVR-LX60
DVR-LX60D

[gltech]

I can't believe this worked for me but it did. My 450h got to where it would freeze up, then got so bad it reported a HDD error every time about 1 minute after powering up (after which you could not do anything at all with the HDD). I replaced the cable, and now it works fine, plus all my recordings are still there. How can a cable go bad like that? I can understand one that's constantly being moved, but one that's stationary?

Thanks hkan!

[snidere]

I can't believe this worked for me but it did. My 450h got to where it would freeze up, then got so bad it reported a HDD error every time about 1 minute after powering up (after which you could not do anything at all with the HDD). I replaced the cable, and now it works fine, plus all my recordings are still there. How can a cable go bad like that? I can understand one that's constantly being moved, but one that's stationary?

Thanks hkan!

Has the E01 come back? I've got the same problem? Hard to imagine that a cable goes. Small currents in this cable.

[alan bache]

changing the cable did not work for me, I seem to have lost my HDD altogether , the HD light comes on briefly, then goes off .
Need to know how to replace hard drive and how much would it cost to DIY it , would appreciate any help on this .lx60d
Alan
christchurch
england